, u na, 20 stern ave. springfield, new jersey 07081 u.s.a. telephone: (973) 376-2922 (212)227-6005 fax: (973) 376-8960 triacs silicon bidirectional triode thyristors ... designed primarily for industrial and consumer applications for full wave control of ac loads such as appliance controls, heater controls, motor controls, and other power switching applications. ? all diffused and glass-passivated junctions for parameter uniformity and stability ? small, rugged, thermowatt construction for low thermal resistance and high heat dissipation ? center gate geometry for uniform current spreading ? gate triggering guaranteed in three modes (mac229 series) or four modes (mac229a series) maximum ratings (tj = 25c unless otherwise noted.) mac229 mac229a triacs 8 amperes rms 200 thru 800 volts (to-220ab) rating peak repetitive off-state voltageo) (tj = -40to 110c 1/2 sine ave 50 to 60 hz, gate open) mac229-4, MAC229A4 mac229-6, mac229a6 mac229-8, mac229a8 mac229-10, mac229a10 on-state rms current (tq = 80c) full cycle sine wave 50 to 60 hz peak non-repetitive surge current (one full cycle 60 hz, tj = 110c) circuit fusing (t = 8.3 ms) peak gate current (t ? 2 u.s) peak gate voltage (t ? 2 u,s) peak gate power (t ^ 2 us) average gate power (tc = 80c, t s 8.3 ms) operating junction temperature range storage temperature range mounting torque symbol vdrm !t(rms) itsm |2t 'gm vgm pgm pg(av) tj tstg value 200 400 600 800 8 80 26 2 10 20 0.5 -40 to 110 -40 to 150 8 unit volts amps amps a2s amps volts watts watts c "c in. ib. 1. vdrm for all types can be applied on a continuous basis. blocking voltages shall not be tested with a constant current source (cont.) such that the voltage ratings of the devices are exceeded. quality semi-conductors
mac229 series mac229a series thermal characteristics characteristic thermal resistance, junction to case thermal resistance, junction to ambient symbol rgjc r9ja max 2.2 60 unit c/w c/w electrical characteristics ( = 25c and either polarity of mt2 to mt1 voltage unless otherwise noted.) characteristic peak blocking currento ) (vd = rated vdrm. gate open) tj = 25c tj = 110c peak on-state voltage (itm = 11 a peak, pulse width =5 2 ms, duty cycle s 2%) gate trigger current (continuous dc) (vd = 12v, rl = 100 1) mt2(+), g(+); mt2(+), g(-); mt2(-), g(-) mt2(-), g(+) "a" suffix only gate trigger voltage (continuous dc) (vd = 12v, rl = 100 n) mt2(+), g(+); mt2(+), g(-); mt2(-), g(-) mt2(-), g(+) "a" suffix only (vd = rated vdrm, tc = 110c, rl = 10 k) mt2(+), g(+); mt2(+), g(-); mt2(-), g(-); all types mt2(-), g(+) "a" suffix only mac229 series holding current (vd = 12 vdc, itm = 2 ma, gate pen) gate-controlled turn-on time (vd = rated vdrm. u-, v-1 oplft; 21 ejjfotpqdhiboeilpufsbockdhicfsibotj z25/6n-12: 93/ 3/ dpouspm4dh!e,nfot.po;!,ddi / v e,nfar,po
